Page 1 of 1
More Questions about AEM UEGO Controller
Posted: Thu Sep 20, 2007 4:23 am
by 1SIKZ31
Ok. This is MORE basic than basic! In other words, I dont know anything.
Theres a 0-5 Volt signal wire coming out of the Wideband...
Where do I connect this to?
Thanks
Posted: Thu Sep 20, 2007 10:30 am
by Matt
NIStune wont use that wire directly
Your UEGO controller should have a serial output (check the manual from the AEM website). That plugs into your laptop
If it doesnt have this.... your only other option is to get a DLP A/D converter and put the 0-5 volt line into this. I stocked up on some more units
Posted: Fri Sep 21, 2007 2:08 am
by 1SIKZ31
oh...
SOMEONE with the UEGO Controller want to enlighten me on this?
Is there a Serial Output or am i going to be needing a A/D Converter?
Posted: Fri Sep 21, 2007 12:10 pm
by Matt
http://www.aempower.com/ViewCategory.aspx?CategoryID=67
- Serial data stream included for output of AFR (RS 232)
Posting from work... I have the manual at home somewhere. It should be on their website where the wires for RS232 are
More info
Posted: Fri Sep 21, 2007 1:40 pm
by Matt
I found that you have to sign up to their forums to get the information, so I have done this ...
http://forum.aempower.com/forum/index.p ... 214.0.html
Attached below are the manuals. Serial connection manual details the plug you have to buiild to connect the UEGO to your laptop.
Once this is hooked up, select your serial port in the NIStune software for Wideband and connect to it
Posted: Sun Sep 23, 2007 5:15 am
by 1SIKZ31
wow.
you dedicated bastard.
matt, your awesome dude, thanks!
