Nistune Forums

So my friend has an m30 ecu rewired to use in a z31, with the z31 wiring loom still and it was wired for a z31 maf, with the type two board already installed, we're trying to wire a z32 maf because we found out that it needs to have a z32 maf to tune with, been searching and searching to find a how to on this subject but to no avail, still having trouble deciphering what actually needs to be done to make this work, the red wire is, pin f is already cut away from the wiring loom

We have Z32 MAF pinouts on our website (Consult and MAF pinouts) what you need is the M30 MAF pinout to map it across

You can work it out:
With ignition on look for 12V using a multimeter.
Find ground (usually) black wire by buzzing output against chasis (there may be two grounds)
Last wire is signal wire, which is shielded usually

Ok so we have got the maf figured out and we cannot get it to start 5.0 motor sports injectors 750cc z32 mad and m30 ecu with type 2 board. We tried k constant of 180 and latency of 850 just backfires we got those values from a local tuner to try and get it to start but no luck. Finding it hard to find the values we need.