Nistune Forums

Hey everyone,

I have an MTX-L and a MTX-D Boost/Shift gauge. I've linked them together and got the two gauges displaying in Nistune but the boost gauge is showing in Bar. Is it possible to change it to PSI?

I didn't do much testing to see if I could get it to change by changing the units in LogWorks. I changed the units in LogWorks then reconnected to the gauges in Nistune but it was still displaying Bar. Do you need to restart Nistune for the changes to take effect?

Anyone done this before?

You will need to configure everything in logworks. Then restart Nistune and reconnect and it should update

The Logworks MTS package defines all the labels and units, we read the information from this at startup