Nistune Forums

Sorry to ask this since it must be documented somewhere,
but how do I configure the LM2 in Nistune?

Selecting 'Innovate MTS' needs a comport .. shouldn't it be USB ?

Thanks for the help,

Andrew

It normally gets recognized as an LM2-USB in the list if the drivers are loaded.

can Logworks connect to it?

note: if you start nistune then connect LM2, you will need to close/open nistune after the LM2 is recognized by MS-windows.

Ok ..

I tried to setup the LM2 without having it actually connected.

I will try as you said.

Thanks