Page 1 of 1
Why is this ghosted (Nistune Consult Display)
Posted: Mon Oct 04, 2010 6:10 am
by Torque
Hi there,
Can anyone tell me why the status fields in the Consult Display are all ghosted?
I am connected to the ECU, everything works fine but these fields are all grayed out ..
It used to work .. what am I doing wrong?
Many thanks!
Re: Why is this ghosted (Nistune Consult Display)
Posted: Mon Oct 04, 2010 12:04 pm
by Matt
Means that likely the consult flags registers are not selected. If we dont see them marked as active I ghost out the display to prevent confusion with thinking that nothing is active (TPS switch, neutral switch etc)
Re: Why is this ghosted (Nistune Consult Display)
Posted: Mon Oct 04, 2010 7:00 pm
by Torque
That's strange ... I changed nothing ..
I will double check.
Thanks Matt,
Andrew
Re: Why is this ghosted (Nistune Consult Display)
Posted: Mon Oct 04, 2010 11:55 pm
by Torque
Strangely enough it was the consult registers.
So it's all fine now.
Btw.
I found that the display shows VCT as well.
Is that working and could I even log that VCT is on/off?
Thanks ...
Re: Why is this ghosted (Nistune Consult Display)
Posted: Sun Oct 10, 2010 12:25 am
by Matt
should display if available in the ECU