Nistune Forums

I got the new aem inline uego wideband but these don`t work whit the nistune software, some one have any information to make work the new wideband? aem part number 30-2310

Regards.

Not much info on these

Does it work with their software?

Instructions here
http://www.aemelectronics.com/inline-wi ... oller-1159

You need to wire in a RS232 connector to the UEGO (grey to PC RX)
BLACK – Connect to a clean power ground.
GREY – Connect to RS232 serial port on laptop/pc. See section on Serial Data Viewing

If you can get it going with their software, then it should work with Nistune assuming they are still outputting the AFRs in text format, like they did with previous models

Hi Matt.
I did that, but doesn,t work whit their software, connet but don't have afr still in 18.00.

I did a test using hyper terminal like the olders and don´t work, try whit 19200 bit per sec and work but the text was in volts not in AFR´s

Let me make another test and post the results.

Thanks.

Try and get their software to work first (contact them about getting it working) and then once that goes then might be good

Can you cut/paste sample output of volts? Normally should stream AFRs like

14.7
14.8
14.6
etc

We just read those and pass straight to the display. If its volts then some extra work is required to translate against an AFR look up table, like with some of the other units I support

I am asking for support here:
http://forum.aempower.com/forum/index.p ... 406.0.html

Saludos...

output definitely different than previously

so looks like volt, status, error string