Zeitronix EGT shows different in Nistune

Anything related to the Zeitronix brand of wideband devices.

Moderator: Matt

Post Reply
Posts: 5
Joined: Tue Jun 09, 2009 12:20 am
Location: Georgia

Zeitronix EGT shows different in Nistune

Post by s14unimog » Sat Jul 10, 2010 7:19 am

Not sure if this has been discussed but I couldn't find it anywhere. My Zeitronix's communicates without a problem, but my EGT display's differently than what is on my Zeitronix DRO. The temperatures shown in Nistune are significantly lower; could it be set to C* or something; I'll have to double check if that is what's showing. If that is the case, I would prefer to see imperial units... Am I missing some configuration window?

Has anyone seen this symptom?

Any thoughts Matt?


Site Admin
Posts: 8745
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia

Re: Zeitronix EGT shows different in Nistune

Post by Matt » Mon Jul 12, 2010 11:04 am

Yes it shows degrees for that unit. Not sure about F*

Okay just looked at the Zeitronix protocol they supplied
Data block: data format
AFR HEX 8 bit
EGT LSB HEX 16 bit
EGT MSB HEX 16 bit
I assume the EGT is C* but it is not very clear. There was a config bit for the LCD to change between C and F but apparently we dont use that

Post Reply