Page 1 of 1

K-konst and Latency for Rb25DET on Z32 ECU

Posted: Mon Feb 01, 2010 1:25 am
by Peace
Hello.
Who got a good runing setup of this?
All images including default got INjector multiplier around 46k inside.
Having such K-const resulting of having etreamly rich.
What i got for now is K-const of 170. But its hard to get idle at 14.7 for this.

Also i'm curious about injector latency. It's set at 720 for now but in provided on board it's 520. Which is correct?

At 520 idling better then on 720.

Can someone provide me a bin from a good runing Rb25DET on stock injectors. Even if its not on the stock AFM.

.....

Posted: Tue Feb 02, 2010 1:56 pm
by BlueRB240
RB20 ecu? or Z32 ecu?

Posted: Tue Feb 02, 2010 2:30 pm
by Peace
Z32 ECU

................

Posted: Tue Feb 02, 2010 2:52 pm
by BlueRB240
I'll try someone else might jump in if we keep batting idea's back and forth here. Did u use a RB25DET address file or was it a Z32 address file?

since it's running richer try and slide the injecton multiplier bar to the left with auto checked at the bottom and watch your A/F ratio till you get close to 14.7 and adjust the latency next.

Posted: Tue Feb 02, 2010 3:04 pm
by Peace
I'm using Z32 address file since its Z32 ecu.

I found value on wich AFR is good. Bu its way far from original 43k.

I'm managed to get idle afr arouond 14 at 172 injector multiplier...

I guess something is really wierd because i'm runing completley stock RB25 and on stock map its completle messed.

Can someone post working map from stock or near RB25DET on Z32 ECU?

.....

Posted: Mon Feb 22, 2010 5:45 pm
by BlueRB240
Bump any luck?

Posted: Mon Feb 22, 2010 6:58 pm
by Peace
SO far i'm using 172 K-const and 750 latency. Check my other thread about timing also. I got some kind of wierd setup.

Re: K-konst and Latency for Rb25DET on Z32 ECU

Posted: Wed Apr 03, 2019 9:48 pm
by Maca
Whats the ecu part number