Hello, I just installed my DW 740CC injectors. The car starts and runs extremly lean and ruff for about 3 seconds. What am I doing wrong.
1.Click Consult
2.Load base image from ECU
3.Resize Injectors-> Factory CC top and 740 in bottem
4. Click Burn to ECU
5. Says burn is succesful.
Car runs like its still using the 370 tune i think.
Resize Injectors not working for Z32
Moderator: Matt
Resize Injectors not working for Z32
Last edited by d_flore on Mon Sep 07, 2009 12:40 pm, edited 1 time in total.
I found a small fuel leak where one of my lines was damaged during re installation of the plenum. I don't think this would make it run rich though?
I will check the multiplier once I can turn my car to the on position. I want to replace that fuel line before I prime the fuel lines.
I cant do any logging because the car kinda hardly runs for a few seconds.
My Wideband shows 50 lol so I guess it could be lean but I dont think it would run at all at 50. I smelled fuel but on second thought that could have been the leak.
P.s. this is for a Z32
I will check the multiplier once I can turn my car to the on position. I want to replace that fuel line before I prime the fuel lines.
I cant do any logging because the car kinda hardly runs for a few seconds.
My Wideband shows 50 lol so I guess it could be lean but I dont think it would run at all at 50. I smelled fuel but on second thought that could have been the leak.
P.s. this is for a Z32