Comparing two maps with different RPM scales

Discuss possible software enhancements/changes here.

Moderator: Matt

Post Reply
CoZZm0
 

Posts: 133
Joined: Fri May 21, 2010 8:07 pm
Location: Sydney, Australia

Comparing two maps with different RPM scales

Post by CoZZm0 »

Hello all...

Recently i've been trying to smooth out the low load stuff as i have had some very bad cold drive issues with the car for a long time that have really started to bug me.

The map i have been running on the car has been rescaled on the RPM to 8000rpm, while a standard map is scaled only to 6800rpm.

Also when the TP scaling has been changed these cells again will be different often with modified

When comparing to two maps, obviously the data points as they diverge will be different and makes it harder to compare. Although this doesn't effect the area i'm focusing on, it is something that i noticed when trying to sort though it all.

Has anyone else encountered such an issue when trying to compare maps ? or is it just something you deal with ?
bachig24u
 

Posts: 678
Joined: Mon Jun 01, 2009 11:46 pm
Location: Campbelltown, NSW
Contact:

Re: Comparing two maps with different RPM scales

Post by bachig24u »

yes, the only way is to fire up two instances of Nistune
Torque
 

Posts: 639
Joined: Wed Jun 16, 2010 10:08 am

Re: Comparing two maps with different RPM scales

Post by Torque »

Yes,

I do use two instances of NT and often use Excel to find a comparable estimate.
NT 'just' compares the figures in the grid and it would be nice if there were a better solution to it.
Post Reply