My car was origanlly a 1985 300zx na 5-speed gll digital dash
but i swapped in a 1984 turbo motor and 1984 turbo ECU (nistune)
my codes are consistent everytime i start the car
-Fuel pump DTC
-Ignition signal DTC
-O2 sensor DTC (intermittent goes away when i clear it)
-speed sensor DTC
my fuel temp gauge is screwd up too its reading backwards
this can be a low priority, since im happy with my car finally running right
DTC codes...
Moderator: Matt
-
- Posts: 32
- Joined: Sat Jun 09, 2007 4:54 am
- Location: Charlotte, NC USA
DTC codes...
1985 300Z 5-Speed GLL Turbo. T-3/T-4 Turbo Upgrade Stage 3, K&N, Certified Muffler 2.5 Exhaust, 420cc Injectors, Walbro 255 Fuel Pump, Eibach Springs,Tokico Struts, MSA Swaybar Kit, Front Mount Intercooler, Greddy Type RS Blow off Valve, Nistune PCM
No probs. I'll add it to the bug list to get looked into some of the Z31 models have a different way of reporting DTC codes
Basically I grab the memory addresses that have the codes in there and try and decode and report them. So far I have found two different ways of the codes being reported
I assume that the ECU is not flashing these codes on the LEDs either?
Basically I grab the memory addresses that have the codes in there and try and decode and report them. So far I have found two different ways of the codes being reported
I assume that the ECU is not flashing these codes on the LEDs either?
-
- Posts: 32
- Joined: Sat Jun 09, 2007 4:54 am
- Location: Charlotte, NC USA