JWT Dual Pop Charger Tune..

Nistune topics related specifically to the 6303 cpu

Moderator: Matt

Post Reply
OEM_Z
 

Posts: 29
Joined: Tue Mar 25, 2008 2:11 pm
Location: Inland Empire, USA

JWT Dual Pop Charger Tune..

Post by OEM_Z »

Hi everyone Im new to tuning so please bear with me... What do I change to adjust for dual pop intakes? Do I double the values in "MAF translation"? Also do I have to adjust something else for it to idle properly? Will I still have to install the "low-speed drivability hose" or can I get away with just adjusting the ECU? Thanks everyone!
Welcome to My DARKSIDE.....
300zxowns
 

Posts: 3
Joined: Tue Apr 22, 2008 1:13 pm

Post by 300zxowns »

sorry i cant help but iam also interested in this, my plan was to wire up 2 mafs and us a safc
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Post by Matt »

Best explanation is in Erics post here
http://ecu2.forumwise.com/ecu2-thread1821.html
easiest way is to use an Apexi AFC/Neo
it will support input of two AFM's and will have 1 signal output.
You can have the Apexi add or average the signal of the AFM's

2 intakes, 1 afm: K x 2
2 intakes, 2 afm + AFC in ADD mode: K x 1
2 intakes, 2 afm + AFC in AVG mode: K x 2

this only applies to twinturbo setups, with seperate intakes
zimzoom_14
 

Posts: 7
Joined: Tue Jan 14, 2020 5:41 pm

Re: JWT Dual Pop Charger Tune..

Post by zimzoom_14 »

Hi Matt and other gurus..
Pls may i ask what a typical setting based on the factory rom for 91 TT manual would be for dual pop, single maf, 550cc injs and Jwt 550s.
I have doubled k to 560 and set TIM to 400.
Latency is at 500.The jwt chip prior to nistune install required 20% increase fueling from 4k-7k on AFC 3 to run safe lamdas.

Now WB afrs are between 14 no boost and 12.5.
We dont have access to any Dynos in this town unfortunately. Car runs fine...but id just like a confirmation that im in the ball park.
My idle fueling cell is at 150...not great but bounces around 14afr.
Tnx and regards
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: JWT Dual Pop Charger Tune..

Post by Matt »

I haven't worked with dual POP so cannot advise with those settings

However you only need to adjust TIM and latency for the injection normally. Injection TIM x 0.67 (370CC/550CC) = 343. Latency I would have around 700uS as a starting point

With standard Z32 MAF K is factory, but with dual POP if that halves the voltage, then double the K would be expected

Those are all starting points.

At cruise adjust TIM until stoich with near 0% trim

On the dyno then you can adjust K so you are running within factory load scale range
Post Reply