Page 1 of 1
Z32 injector latency setting 740cc
Posted: Sun Aug 09, 2020 5:43 am
by Gonzo12c
Hey folks interested to hear what people have their injector latency set to for Nismo 740cc injectors? Wanting to copy for a base map as I’m currently set to 830.
Re: Z32 injector latency setting 740cc
Posted: Fri Aug 14, 2020 10:31 pm
by Matt
Had my S14 set to 900uS but that wanted a rich idle (13.5ish:1)
Usually I suggest once you have your base mixtures (stoich at cruise with no trims) then set latency so you get a nice idle
Re: Z32 injector latency setting 740cc
Posted: Sat Aug 15, 2020 12:00 am
by Gonzo12c
Thanks I had looked at the Tomei 740s and they have a time lag setting of 0.66 so I thought it might be 660 but that seemed low. Will push up to 900 and see how that responds. My cruising AFR is looking good now and I’m idling around 12.4. Have started AFR auto tuning and getting some violent spikes in the fuel map at the moment so will continue with it until I get a happy medium and fine tune the map.
Re: Z32 injector latency setting 740cc
Posted: Sun Aug 16, 2020 8:21 pm
by Matt
I would normally recommend manually tuning the fuel map. The violent spikes can happen because of rich/lean AFRs on deceleration etc than then adjusts the fuel map accordingly
Re: Z32 injector latency setting 740cc
Posted: Sun Aug 16, 2020 9:16 pm
by Gonzo12c
Sure I was trying it out to see how well it worked. I did find a target AFR map in the install and used this whether it is correct to be using this though?
Re: Z32 injector latency setting 740cc
Posted: Mon Aug 17, 2020 9:35 am
by Matt
Normally the target map should be about 14.7:1 cruise and 11.5:1 on boost. The factory maps seem to show richer with the 'estimated AFRs' so I don't normally recommend using it
With the AFR auto tuner, you may need to adjust speed trigger and TPS decel cut to avoid spikes happening during the adjustments
Re: Z32 injector latency setting 740cc
Posted: Wed Aug 19, 2020 10:29 am
by PL
People seem to get hung up on getting latency set exactly as per injector manufacturer's specs. I can understand this when using aftermarket ECU's with fuel models that rely heavily on an accurate latency number. But in reality I've found that for Nissan ECU's it doesn't matter that much - within reason of course. I always start at a latency number close to the manufacturer's spec (if known), get my tune roughly in place, then watch the fuel trims and tweak latency to suit.
Naturally you need to ask questions if you're having to use unrealistic latency figures but don't be afraid to give them a nudge to get your light light/idle AFR's correct.
PL