R32 ECU 11U10 cooked IC14 (possible resistor pack)

Nistune topics related specifically to the 6303 cpu

Moderator: Matt

Post Reply
bachig24u
 

Posts: 677
Joined: Mon Jun 01, 2009 11:46 pm
Location: Campbelltown, NSW
Contact:

R32 ECU 11U10 cooked IC14 (possible resistor pack)

Post by bachig24u »

Hi Matt,
A customer just brought his trusty 11U10 ECU back too me after a few years that has previously ran;
an RB20DET in R32
then
RB25DET in an R33 with V4 firmware version.

now he installed the 11U10 w/V4 firmware back in his R32 to run his RB25DET
and tried priming the fuel pumps and smelt horrific toasting component scent.

Sounds like the customer has rewired something wrong along the line.
He also mentioned, low fuel pump pressure during priming but from memory the RB20 has a pump controller and requires TPS 'off' condition to increase pump voltage.

Please can you advise if possible what IC14 controls so I can give him a starting point to go trace wiring looms back.

Any help greatly appreciated.

KR
Sime
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: R32 ECU 11U10 cooked IC14 (possible resistor pack)

Post by Matt »

IC14 controls the coil driver outputs. Anything to do with coil packs would be a good start. Replacement ECU will be needed as these are a ceramic coated circuit board from Nissan

You may be able to use a similar device from R33 ECUs if you have any spare and exchange over
bachig24u
 

Posts: 677
Joined: Mon Jun 01, 2009 11:46 pm
Location: Campbelltown, NSW
Contact:

Re: R32 ECU 11U10 cooked IC14 (possible resistor pack)

Post by bachig24u »

Thanks Matt.

I'll get it looked in to. maybe the coil pack loom is broken somewhere.
bachig24u
 

Posts: 677
Joined: Mon Jun 01, 2009 11:46 pm
Location: Campbelltown, NSW
Contact:

Re: R32 ECU 11U10 cooked IC14 (possible resistor pack)

Post by bachig24u »

Found out that customer is using an RB25 ignitor module.

Can any confirm if they are interchangeable?
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: R32 ECU 11U10 cooked IC14 (possible resistor pack)

Post by Matt »

Should be fine in an R32 since we switch the ECUs to drive the module in the RB25s anyway
bachig24u
 

Posts: 677
Joined: Mon Jun 01, 2009 11:46 pm
Location: Campbelltown, NSW
Contact:

Re: R32 ECU 11U10 cooked IC14 (possible resistor pack)

Post by bachig24u »

Thanks Matt.

I might have to go onsite and investigate this one.

UPDATE: Coil pack loom had a few cracked wires.
the loom was twisted during installation and was probably sending 12v back to the ECU via coil pack 1 return wire or ECU ground.
Post Reply