Rb30 injection limited

Nistune topics specific to the 6802 cpu

Moderator: Matt

Post Reply
Ryanrb25
 

Posts: 3
Joined: Tue Sep 24, 2019 9:22 pm

Rb30 injection limited

Post by Ryanrb25 »

Hey guys,

Have a stock rb30et with a base rb30et map loaded....under a full load pull, not necessarily to rev limiter, this message is logged each time

CAUTION: ecu load (tp) max reached. Injection limited. Increase table values

What can cause this on a standard map with a standard setup?

Thanks
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Rb30 injection limited

Post by Matt »

Warning means that TP value has hit the standard TP max limit map. It is just a warning in case you are concerned injection isn't going any higher.
Ryanrb25
 

Posts: 3
Joined: Tue Sep 24, 2019 9:22 pm

Re: Rb30 injection limited

Post by Ryanrb25 »

Thanks Matt,

This is an unmodified engine with an unmodified nistune map.

Not something I should be immediately concerned about prior to getting a tune?

Thanks
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Rb30 injection limited

Post by Matt »

From what you described, I don't think so. The TP max maps are fairly low but those ECUs are tuned for low boost also (thinking 6-8psi factory?)
Ryanrb25
 

Posts: 3
Joined: Tue Sep 24, 2019 9:22 pm

Re: Rb30 injection limited

Post by Ryanrb25 »

Yep. 6psi

Thanks for the reply
Post Reply