Nistune Forums

Hi Matt,

It would be good if there was a way to lock the timing to a specific value (e.g. 15 degress) so that it can be checked with a timing light.

I tried using the Active Tests - Base Timing option to do this, but it did not seem to do anything (RB30E ECU).

Cheers,

Martin

This function is only available with Nissan consult ECUs

Earlier Type 1 ECUs will push out consult data, but active tests is not available (and will not be) for these models

I suggest follow the factory service manual, disconnect TPS sensor with coolant temp around 80 degC and it should sit on the 15 deg BDTC cell on the timing map

Ahh, that explains it. Thanks Matt.