Flex Fuel Gauges

Discuss software bugs and related problems here.

Moderator: Matt

Post Reply
Zedstar
 

Posts: 19
Joined: Wed Feb 24, 2016 5:03 pm
Location: Melbourne , Australia

Flex Fuel Gauges

Post by Zedstar »

Have just installed Flex Fuel Board and sensor , gauges display but do not operate. ECU is 300ZX Z32

Has anyone else had this issue ?
Attachments
image.jpeg
(570.37 KiB) Downloaded 973 times
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Flex Fuel Gauges

Post by Matt »

Is flex fuel enabled, is there ethanol in the system? They wont display a reading unless above 0% ethanol
Zedstar
 

Posts: 19
Joined: Wed Feb 24, 2016 5:03 pm
Location: Melbourne , Australia

Re: Flex Fuel Gauges

Post by Zedstar »

It is Flex Fuel enabled with 100% e85 in tank.
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Flex Fuel Gauges

Post by Matt »

Check installation of the flex board, and that there is about 5V between black wire and green wire using a multimeter in the ECU
Zedstar
 

Posts: 19
Joined: Wed Feb 24, 2016 5:03 pm
Location: Melbourne , Australia

Re: Flex Fuel Gauges

Post by Zedstar »

Have checked all voltages , Green OP wire 3.5v. Led flashes when sensor disconnected. It is the 8 bit ECU
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Flex Fuel Gauges

Post by Matt »

Expert mode:

Display > Consult RAM tracer

Trace address 1401 (diag input) length 01

Let me know if this is 00 or something else when there is the voltage input on the diagnostic line
Post Reply