Page 1 of 1
No 02 voltage , no K value window ....etc (photos)
Posted: Wed Feb 27, 2019 7:32 pm
by louiswun
As title, V1.3
No O2 voltage report under the bar,.
Standard ENT S13 50F00
Standard ENT S14 69F00
No K value window pop up
Standard ENT S13 50F00
Didn't try on S14 ecu
Error message
Something like raise the rev limiter , show up when tip in the throrttle only
Standard ENT S13 50F00
Others ecu not tried .
Re: No 02 voltage , no K value window ....etc (photos)
Posted: Wed Feb 27, 2019 8:12 pm
by Matt
No O2 voltage report under the bar
1. Did you select the O2 LHS register when connecting?
Right click desktop > channels and check O2 voltage selected
2. Does O2 voltage show under Display > Consult RAW registers?
Re: No 02 voltage , no K value window ....etc (photos)
Posted: Wed Feb 27, 2019 8:14 pm
by Matt
Something like raise the rev limiter , show up when tip in the throrttle only
Standard ENT S13 50F00
Image shows no speed input. Were you reving the engine with no speed input? If so then it may be close to the 'safety RPM' speed limit, which is why the message came up
S13 SR20DET does not actually use the safety RPM (most other Nissan ECUs do), but try increasing this safety RPM parameter and let me know if still a problem
Re: No 02 voltage , no K value window ....etc (photos)
Posted: Wed Feb 27, 2019 8:19 pm
by Matt
No K value window pop up
Standard ENT S13 50F00
See below... it's just hiding
Re: No 02 voltage , no K value window ....etc (photos)
Posted: Wed Feb 27, 2019 8:23 pm
by Matt
Other thread:
viewtopic.php?f=5&t=3667
Shows its an initial display issue with the window in question.
Windows > Cascade Windows to show it
Re: No 02 voltage , no K value window ....etc (photos)
Posted: Wed Feb 27, 2019 11:14 pm
by Matt
Just something I remembered... the default display setup is from one of my machines which has TIM and K open by default at bottom lhs of screen. If you are running a low resolution display then they won't be visible. Not a bug but cascade windows will realign them to a visible position.
I may just delete these from the default UDF file so anyone else using older displays doesnt have the same issue