Nistune wifi adapter

Discuss hardware enhancements, suggestions, and wishes here.

Moderator: Matt

Post Reply
simono
Posts: 2
Joined: Sun Sep 13, 2015 7:26 am

Nistune wifi adapter

Post by simono » Mon Feb 22, 2021 5:57 am

Hello!
I've made tcp<->consult bridge over WIFI. Using diy consult wifi adapter and Tibbo virtual COM driver.

Works like this:
https://youtu.be/UT316hFZfOg

Made a lot of work in tuning tcp/ip stack for minimal delays and fast connect. Now it is near as fast as wire connection and twice a time faster than BT in Tuner Mode:
wire_wifi_bt.jpg
wire_wifi_bt.jpg (156.33 KiB) Viewed 1480 times
Is such an adapter can be usefull? Full halvanic isolation and easy connection. In theory, if Nistune SW will support TCP connection with custom delays, it can yeild in much speed improvement in Tuner Mode.

Matt
Site Admin
Posts: 8700
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Nistune wifi adapter

Post by Matt » Tue Feb 23, 2021 7:51 am

Nice work!

The main delay is the speed of the consult which is limited to 9600bps (1200 characters/sec so 1.2 char/ms)

We can increase the clock rate in the processor to a higher rate, but then this needs to be done both sides (in firmware, and software) to match. If the rate is incorrect one side then there are no more comms. I think we can up to about 19,200 but I would need to check the 6303/7790 datasheets

simono
Posts: 2
Joined: Sun Sep 13, 2015 7:26 am

Re: Nistune wifi adapter

Post by simono » Sat Feb 27, 2021 6:45 pm

Hello, Matt! I was PMd you to mail address in your contacts(@yahoo). Or, please, PM me, how I can contact you.

Matt
Site Admin
Posts: 8700
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Nistune wifi adapter

Post by Matt » Mon Mar 01, 2021 10:08 am

Got the email thanks

Post Reply