AEM UEGO setup

Anything related to the AEM brand of wideband devices.

Moderator: Matt

Post Reply
Matt
Site Admin
Posts: 8219
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

AEM UEGO setup

Post by Matt » Sun Apr 07, 2019 2:53 pm

There are about 15 topics on this wideband in this area so I'll combine things together in this thread

There are two ways to get UEGO data into Nistune
1. Serial connection.

Purchase a FTDI based USB-serial converter, and DB-9 connector

Connection info here:
download/file.php?id=268

Other brand may not work properly. See:
viewtopic.php?f=33&t=3155
viewtopic.php?f=33&t=2775

BLUE - pin 2 of DB9 connector
BLACK - pin 5 of DB9 connector

Solder the connector to the UEGO and check firstly using terminal program
http://www.hilgraeve.com/htpe/download.html

or try teraterm
http://hp.vector.co.jp/authors/VA002416/teraterm.html

1. After install click Serial and select COM port
2. Default settings 9600 / 8 bits / no parity are already set so you should receive data straight away

Image

After this works, close the terminal program, select AEM UEGO, same COM port, connect inside Nistune (see Software Users Manual - Wideband section)

2. DLP A/D converter. Ground all unused inputs, except Channel 1. Otherwise you get noise
viewtopic.php?f=33&t=1892

Then connect 5Voutput to Channel 1, and sensor GND to DLP ground

Fail safe requires the com0com emulator. More notes here:
viewtopic.php?f=33&t=3078

Matt
Site Admin
Posts: 8219
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: AEM UEGO setup

Post by Matt » Sun Apr 07, 2019 3:05 pm

Part 2 testing inside Nistune 1.3.2
Attachments
UEGO_test2.PNG
UEGO_test2.PNG (30.07 KiB) Viewed 1313 times
UEGO_config1.PNG
UEGO_config1.PNG (32.27 KiB) Viewed 1313 times
UEGO_test1.PNG
UEGO_test1.PNG (11.23 KiB) Viewed 1313 times

Post Reply