Consult will not connect

Discuss hardware problems here.

Moderator: Matt

Post Reply
Aer003sr20det
 

Posts: 4
Joined: Wed May 29, 2013 11:58 am

Consult will not connect

Post by Aer003sr20det »

I got my ecu back Monday from dds performance and they soldered in my type 3 board. I have a 1995 200sx se-r with a swap sr20det bluebird u13. Does it matter if you have a obd2 jumper harness to connect to obd1 ecu? I download ftdi and nistune. But I tried fixing it in the drive manger but everything comes up but the plms consult cable comes up as nistune programmer device. The car runs but it runs rough and goes lean.
Aer003sr20det
 

Posts: 4
Joined: Wed May 29, 2013 11:58 am

Re: Consult will not connect

Post by Aer003sr20det »

I tried my other sr20de ecu and it works but still does not work with sr20det ecu (1E000).
Aer003sr20det
 

Posts: 4
Joined: Wed May 29, 2013 11:58 am

Re: Consult will not connect

Post by Aer003sr20det »

I believe it is my jumper harness and I looked at it and the diagram to splice the wires in. I found I am missing 7 for rx, 15 for tx, and 14 for clk.
Aer003sr20det
 

Posts: 4
Joined: Wed May 29, 2013 11:58 am

Re: Consult will not connect

Post by Aer003sr20det »

It was the missing rx, tx,and clk on the ecu and got it running now.
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Consult will not connect

Post by Matt »

Okay just saw this. Good to see you got it sorted
Post Reply