Page 1 of 1

Innovate MTX-D gauge

Posted: Mon May 31, 2021 11:23 pm
by Matt
Today I did a MTX-D install for a customer. This is an R34 ECU. I also wired the evap solenoid to the boost cut output, so we can use the boost control using a 3 port MAC valve by ethanol content

As usual, it took a lot longer than expected and I had to supply half a Nistune flex kit to get it finished

Attached are pics of the install. Basically get the power from the ECU, and the yellow wire to the ECU for ethanol content.

Also the white wire should be wired to the headlight for dimming (job for the customer)