Page 1 of 1

ECF1 Wideband and Ethanol blending into Nistune

Posted: Sun Jul 21, 2019 2:05 am
by wilsonthesphere
https://www.innovatemotorsports.com/products/ecf1.php

Question for Matt or who ever else has tried the ECF1 unit. I sure the wide-band would work fine because it uses innovate MTS Serial protocol but wanted to confirm if the Ethanol blending would work. Innovate states it has analog output for ethanol of 0v-5volts so I wouldn't need the flex fuel converter board just wire it into the ECU. This would installed for a TYPE 1 board feature pack installed.

Re: ECF1 Wideband and Ethanol blending into Nistune

Posted: Mon Jul 22, 2019 6:39 pm
by Matt
I've not tried it, but if the ethanol output is similar to ours and the Innovate ECA-2 where 0V = 0% and 5V = 100% ethanol then you can wire it straight to the ECU diag input