can not find innovate under wide band type

Anything related to the Innovate brand of wideband devices.

Moderator: Matt

Post Reply
that guy
 

Posts: 64
Joined: Thu Aug 30, 2007 3:05 pm

can not find innovate under wide band type

Post by that guy »

same as above cannot connect and could'nt find innovate under wide band type look up table configured
bachig24u
 

Posts: 677
Joined: Mon Jun 01, 2009 11:46 pm
Location: Campbelltown, NSW
Contact:

Re: can not find innovate under wide band type

Post by bachig24u »

Do you remember if you ticked the box for innovate .. during the installation or upgrade questions inthe install wizard?

must have LOGWORKS 3.07 installed before NIStune.
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: can not find innovate under wide band type

Post by Matt »

Next release I've removed the tickbox (always install the LogWorks SDK OCX) however since the DLL needs to be from LogWorks3 to work properly, if it is not detected then you will be notified when selecting 'Innovate MTS' inside File > Configuration
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: can not find innovate under wide band type

Post by Matt »

Next release I've removed the tickbox (always install the LogWorks SDK OCX) however since the DLL needs to be from LogWorks3 to work properly, if it is not detected then you will be notified when selecting 'Innovate MTS' inside File > Configuration and prompted to reinstall LogWorks
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: can not find innovate under wide band type

Post by Matt »

Note also - Windows Firewall can block 'Innovate MTS' from being available in Nistune. If after reinstalling logworks still not showing then enable Nistune through the firewall (or disable the firewall on private network to see that this is the issue temporarily)
Post Reply