Type 1 board preprogrammed for type 2 ECU

If it isnt a problem or a suggestion it probably goes here.

Moderator: Matt

Post Reply
midian
 

Posts: 43
Joined: Wed Jan 14, 2015 10:16 am

Type 1 board preprogrammed for type 2 ECU

Post by midian »

Hi all, I definitelly sure I'd read here (or at z31p forum - not sure exactly, pretty sure it was here) that it possible to use type 1 board in type 2 ECU.
I also remember Matt confirmed this, but I can't find topic =(
I have nistune base image programmer, so can DIY.

So, I don't remember what should I do - simply upload base image with ADR on bord, or some extra.
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Type 1 board preprogrammed for type 2 ECU

Post by Matt »

Most probably not. It depends... F700-F7FF is reserved on most Type 1 boards for USB comms. So if the Z32 image uses that address area for its own program code then it wont work
Post Reply