HPX N2

If it isnt a problem or a suggestion it probably goes here.

Moderator: Matt

Post Reply
Augustus Maximus
Posts: 3
Joined: Mon Oct 29, 2012 10:29 pm
Location: Connecticut USA

HPX N2

Post by Augustus Maximus » Thu Mar 30, 2017 6:17 am

Is there support or upcoming support for this MAF. PMAS sent an N2 by mistake and I'm wondering if I should go ahead with it. Advice?

Matt
Site Admin
Posts: 8222
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: HPX N2

Post by Matt » Thu Mar 30, 2017 10:44 am

No there were no plans for this sensor. You could ask PMAS for the N2 MAF polynomials and then these can be used with the 'Transfer Generator' inside Nistune to make your own curve however

Augustus Maximus
Posts: 3
Joined: Mon Oct 29, 2012 10:29 pm
Location: Connecticut USA

Re: HPX N2

Post by Augustus Maximus » Thu Mar 30, 2017 4:33 pm

On their site it seems the N2 is actually an N1 but with the Nissan pinout. They share the same polynomials

Matt
Site Admin
Posts: 8222
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: HPX N2

Post by Matt » Sat Apr 01, 2017 9:50 pm

Okay so you can use the same selections as the N1 in the Nistune software... all good

Post Reply