Bosch maf HFM5 sensor 0 280 002 421, 0 281 002 421

If it isnt a problem or a suggestion it probably goes here.

Moderator: Matt

Post Reply
midian
 

Posts: 43
Joined: Wed Jan 14, 2015 10:16 am

Bosch maf HFM5 sensor 0 280 002 421, 0 281 002 421

Post by midian »

Hi all, but generally Matt.
there are bosch hot film sensors (same as gtr or z32 type), which capable to measure up to 1200m3/h.
They re rare counterfate, and not so expensive as new oem z32.
but the problem in correct voltage.
If I don't mistaken, in early (0.9.xxx) revisions of ECU it was possible to make custom VQ MAF map.
in current can't find, or, at least understood volume numbers. I'm attaching diagrams from open sourses for Z32 maf and bosch (0 280 002 421).
Attachments
nismo_afm_ed.jpg.jpg
(91.65 KiB) Downloaded 808 times
Bosch_HFM5_MAF_sensors.jpg
(407.39 KiB) Downloaded 808 times
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Bosch maf HFM5 sensor 0 280 002 421, 0 281 002 421

Post by Matt »

You can use Operations > VQ Map Transfer Generator to create a curve if you have the polynomials

Otherwise direct editing the 64 points in the VQ map

You should be able to extrapolate a full 64 points form those voltages listed in the table for the part number you have there
midian
 

Posts: 43
Joined: Wed Jan 14, 2015 10:16 am

Re: Bosch maf HFM5 sensor 0 280 002 421, 0 281 002 421

Post by midian »

Understood.
Well,64 points.... Those points I have + ms Excel :p
midian
 

Posts: 43
Joined: Wed Jan 14, 2015 10:16 am

Re: Bosch maf HFM5 sensor 0 280 002 421, 0 281 002 421

Post by midian »

I think minimal coerrection to be done (see image)
Image
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Bosch maf HFM5 sensor 0 280 002 421, 0 281 002 421

Post by Matt »

Try and extrapolate that out to 64 points. Then it can be assigned into the VQ map grid directly
Post Reply