Page 1 of 1

Tune input ka24de-t

Posted: Mon Feb 26, 2018 1:15 pm
by EnnEssEnnKAT
This will be my first summer with my turbo ka24de engine and I need some general input. My logs show I need some work on the ignition map mainly. Others I've viewed have some ups and downs in the high load cells, mine only is slightly changed in those columns. Previous tune I had was flat in those columns and I added some ups and downs.

The log timing appears to retard until I hit full boost pressure and once the wastegate opens it then slowly advances and I'm not sure if that's correct. I really need some input on the correct trend of timing from WOT --> Full Boost --> Rev limiter. 'I'm running about 10 psi in this log. my arf is reading well over the whole rev range, usually 11.5 to 12:1 at WOT. Any input is welcomed.

Re: Tune input ka24de-t

Posted: Thu Mar 01, 2018 9:17 am
by Matt
Curious as to why you lifted the whole fuel map higher (base was -6 in original values, and now 7 in new map)

I played back the log and there is a bit of timing reduced around the mid - top end. It might be knock detection retarding timing.

Have a look through our knock sensor tech notes:
http://nistune.com/docs/KnockGuideSR20.pdf

Re: Tune input ka24de-t

Posted: Tue Mar 20, 2018 2:08 am
by EnnEssEnnKAT
Matt wrote:Curious as to why you lifted the whole fuel map higher (base was -6 in original values, and now 7 in new map)

I played back the log and there is a bit of timing reduced around the mid - top end. It might be knock detection retarding timing.

Have a look through our knock sensor tech notes:
http://nistune.com/docs/KnockGuideSR20.pdf
It's a good question, and I think that was the result of copying a known-good fuel map and appending it to my setup. I did fidget with the K-const. and inj. latency a bit to get those dialed in and the AFR gauge looking good, so it must just be how it is. Not a big deal to keep it that way? Thanks.

Thanks for the link to the knock guide, it has a lot of good info in there. I will make a run with and without knock detection enabled and see how they compare to start.

Re: Tune input ka24de-t

Posted: Tue Mar 20, 2018 9:13 am
by Matt
You could adjust the fuel map a bit back to normal, and use TIM to then fix up the base mixtures again, as long as your AFRs look correct