Nistune Forums

Hey Matt,
How about IMPUL tunes? Are they conservative also?

yours might be an older board with tighter restrictions on the allowable read/write window on the board I suggest removing those two entries in the address file In the meantime I'll try and work around those errors so they dont become an issue with updated address files in the future (just means ma...

you are using a custom address file.... can you post it here? i tried the standard M30 address file in the beta version from the selection list and that works fine in regards to pulling the maps off Looks like your address file has an entry at 7FE0 which is outside the range of the board There is a...

I have an M30 ecu in the Z31. It has been working great. However, today came up with a problem. Nistune was working just fine yesterday but the version was old so today I updated my software to the 0.9.6.1b version. Did some updates to my bin and tried to sync from computer to ecu. Got a write error...

Make sure Nistune is using the proper port. With USB the port will not be Serial 1 or 2, it may be like serial 5. I have run into that. Also if it is a USB adapter, I have found that not all work the same and some may not work for this program.

If you have the M30 ecu in your car, I have found something that helped me greatly. I have the M30 ecu with 10 ohm resistors for the low impeadance injectors. I had to move the injector latency to 2100 to make the idle almost smooth as butter. Also moved the fuel mapping in the idle area up about 50...

At least you did not forget me.

send me a debug log through with just the wideband connected. I can have a look at the output and work it from there have you setup your wideband directory to the techedge subdirectory to pick up the correct translation tables? Table file. Oh. I just put in the folder address but not directly to th...

Hey Matt, I have an older 2A0 that is working perfectly with a USB adapter and it's own software. However, I cannot get it to display the AFR in Nistune. It is reading it and lets me know the status of it IE: heating up, warming, normal operation. Just no readout. I have only three wires attached in...

Have some questions on the M30 address file that is included with Nistune. 1. I have an old M30 address file also from before Nistune. I have noticed that both the old file and your Z32_VG30_256_E address file have HighFuel 7D00 and RegFuel 7000 where the Nistune M30 address file has HighFuel 7D00 a...

Back to the vh45 question.
How about a larger nvram?
http://www.st.com/stonline/products/fam ... /nvram.htm

Theres three offsets you can changed Gauge: CONSULT_TIMING_OFFSET= Table: IDLE_TIMING_MAP_OFFSET= Map: TIMING_MAP_OFFSET= Add which ones you need to the address file with the offset required. I didn't realise M30 had a different offset That did it. Changed the CONSULT_TIMING_OFFSET=40 and that work...

Is there no way to place a larger nvram onboard?

Also, on my M30 ecu, the timing is way off. Or actually the offset is off. It is reading 60 degrees but is set at 20 according to my timing light. Any hints?

Hey Matt, Just wanted to let you know that I put the Version 2 M30 ecu in my 50th anniversary today. Man that is nice. Tuning via the consult plug is awsome. So much nicer than the usb interface of the Z31 Nistune. I would like to find out if you offer Nistune for the Q45 engine? I am looking at pla...