Nistune Forums

Ed, could this happen on a Supercharged Micra engine also?

what is Yours ECU number baguete? both car I can't do were 23710-82F09 but Pete put 82F08 image on them as there was problem with running original 23710-82F09 image ... I also try on both car's one ECU without NIStune board but also without success . Its 23710-74B01, K11 Facelift 1 ECU. Im using Ty...

Matt wrote:I'll have to try it again then. Probably use Jez's NATS sync tool in the interium. I dont have a NATS vehicle to test it out on here

With H-Dev NATS Sync it happens again, no recode possible, only Nissan Dealer can recode it...

I try NATS synchronization with two S14a EDM without success with NIStune version 0.9.14.01 and 0.9.14.02 I put new ECU put contact , connect Consult and then press NATS synchronization and confirmed Yes on pop window, it just said NATS response 0 in down left corner and nothing happen ECU lamp is ...

Fusion Ed wrote:I have never tried more than two, so I cannot say for sure.

Ok, thanks

Key in ignition on Sync (ECU light should stop flashing and stay steady) IGNITION OFF Second key in ignition on Sync (ECU light should stop flashing and stay steady) IGNITION OFF Test both keys. Do not try to start between adding keys. Hi Ed, how many keys can NATS take? I was told 3, other say 4...

skylinegtrhr wrote:Thanks I must try it with NIStune function.

Youre welcome.

I never used that NIStune function, but i will give it a try...

I didn't maxout SR20DET AFM with standard SR20det engine and GT28RS (but on only 0,8 bar another experiment it had 0,5 V less than maximum flow) so I think it will be enough for Micra. So, the 250hp max that nistune software indicates for a SR20DET AFM its correct. Many thanks, i will source a SR20...

I used H-DEV NATS recoder and it works fine on S14a and K11. The K11 gives an error at the end of the recode but Check Light went on and car started ok... And what is procedure for synchronization? If You can please put "Step by step" procedure. Its easy, just connect Consult cable on bot...

Yes, i understand that HP figures are not related with the AFM. I asked that because i will mod a K11 Micra (with a supercharger) and i need to relocate the AFM, throttle body and air filter, and the stock AFM and butterfly are very restrictive. So, using 1,2bar @ 14000rpm of supercharger speed on a...

Hi,

what HP max does a CA18DET MAF can handle?

As far as i can see on the software, its 190hp, but Stage 2 on a CA18DET has more than that and use stock MAF.
So, what is the real figures about this MAF?

Thanks

I used H-DEV NATS recoder and it works fine on S14a and K11. The K11 gives an error at the end of the recode but Check Light went on and car started ok...

Matt, you're the man... :P When you have Type5 board ready, tell me something. PS: Another thing, im having issues with the fuel cut (i think its the fuel cut). When engine gets to 7250rpm, it cuts, but only in 3rd, 4th and 5th gears, on 1st an 2nd gears it continues to accelerate and goes to 8.000r...

Hi, Matt manage to make NIStune Type4 board compatible with Micra K11 Facelift (98-2000), so one more vehicle to the list.
Already installed it and works like a charm, good work Matt, thank you very much.