Nistune Forums

forgot to post up...

ended up making maf blow through on upper chargepipe and no issues. car made 248whp 230wtq @ 9.5psi.

here's the datalog, unfortuneately it was w/ the older bin that i accidentally over-wrote w/ the most recent. it had the map that didn't have enough resolution. if you play it in the newer map it doesn't over-run the map. i'll make the changes you suggest. i think we'll see if we have enough room to...

here is the most current map, that i rescaled maf and then adj inj mult k to get basic afr close on part throttle. it isn't the one i was using prior that had maf and inj rescaled w/ too low load scalar hitting/overrunning table. suck through maf and it would be what i would consider too close to th...

95 s14 ka-t, z32 maf (suck through), sti 550cc inj, atmospheric bov. 1 load addy file for s14 ka 2 open bin for 95 s14 ka 3 select change afm commit and ok 4 select change inj and map changes to very low load resolution and hits the end of the map @ atmospheric or very low boost 5 started over with ...

worked everything out the day after the last post. turns out when the swap was done at another shop the consult connections were never wired in. car ended up making 322whp and 284wtq @ 17psi. starts, idles, and drives like stock (with exception for the extra whp). great product and look forward to t...

i don't find it listed in the equipment applications and i've seen where sr20de(t) ecu have been used w/ a seperate module for vvl, but is there a board that will work that nistune offeres w/o having to do the workaround using the sr20de(t) and vvl hack? customer showed me his ecu that he has a boar...

never connected before...this is the first nissan i've done.

device manager recognizes and I followed the install/driver instructions. i'll have my guys check the wiring again and maybe just jump some wires off the ecu connector to connect directly to my consult connector.

pump primes for a good 5 seconds, but car doesn't start and consult doesn't connect.

i'll look over the guide again to see if there is something i've missed.

sr20det redtop 550 cc inj n60 maf s13 wiring harness s14 chassis 50f00 ecu with type 3 board have programmed and re-programmed board using base image programmer and sr20det redtop 50f00 base image, but to no avail. cannot connect via consult. first, found out wires weren't even connected. connected ...