Nistune Forums

So can I just replace the ignightor with one of these ? And then I’m good to go ? Thanks Matt

Can I upgrade to r35 coil packs and delete the igniter chip . Do I have to make any changes in the ecu?? Thanks

Matt wrote: ↑Sun Feb 10, 2013 1:45 pm what is the part# of the ECU. I can check it out

So you have speed limiters at maximum, and RPM limits about 8000rpm, and TP limit table set to high values?

Hi Matt does setting speed limiter 1 & 2 Completely disable the speed limit on a s13 SR20det Black top with FP

Thanks I replaced the alternator and it’s all good now

Hey PL a little oddf topic bud to you still sell the conversion box that can convert my speed sensor output to my ecu speed sensor input ? Thanks

Another option I have found is this gps speed sensor that has a Tacho output . I don’t know the ecu speed Input so don’t know 100% if this would work ? Maybe Matt can confirm please In order to use this sender as a speedometer sender, your speedometer must can setup pulses/mile to 16000, if your spe...

Been doing some research on how to convert the Hall effect speed sensor on gearbox to wire to the ECU vehicle speed sensor input .


Found this online . Figured I would give it a go , will let you know the outcome .

Hi all I have a MGB roadster with s13 sr20det swap. Went out Driving this afternoon And everything was great . It started getting dark so I turned driving lights on and then issue started . Motor would splutter from idle to about 2,500-3000 rpm then come good at higher revs . AFR gauge showed it was...

Hi Matt , will this also work for the cold start . Make the revs higher when starting cold ? Thanks

Hi , I can’t use the factory IACV as I have a greedy intake manifold and had to blank the IACV off as it was in the way of the steering column (the SR20det is now in my MGB roadster). Cold start is a real pain so I would like to do something about it. Can I install a universal 2 wire IACV , will it ...

Hi all , recently installed a bov to atmosphere and driving it feels and sounds great 🤣 , I have it wound up to full tension as I really only installed it because I’m running 18psi and probably go higher in the future and feel the turbo will appreciate the relief 🤣. my only issue is after long decel...

Matt wrote: ↑Tue Jan 28, 2020 4:59 pm You could use a LED + resistor (about 333 ohm or nearby like 470 ohm) from the CEL output to 12V, or a light similar current to dash lamp if you wish

Thanks Matt , can you please explain in more detail as I’m not 100% sure how to wire in the resister . And I can use a 12 led . Thanks

Thanks Matt , can you please explain in more detail as I’m not 100% sure how to wire in the resister . And I can use a 12 led . Thanks

I have successfully wired in my launch control button but as I dont have a factory dash cluster how can I wire in a light so I know my launch control is activated Also As I dont have a speed sensor I have to press the button once to activate the LC and then again during the launch when I want to dis...

Hi Matt does this mean I need to press the switch when I want to disable the launch control during my launch?

Hi I have a s13 SR20det in my MGB roadster , I want to setup the nistune launch control but need the speed sensor to talk to the ecu . Is this possible ? I have done a little research and it seems the speed speed sensor sends signal to the cluster and the cluster sends signal to the ecu. Is there a ...