Nistune Forums

Hey Matt can you look at this log i have some weird issue im not sure whats causing it. You can see in the log afr go max lean or max rich for a split second. When it goes max rich i start to hear ticking noise from the engine injector maybe. Its not a knock its only after engine is fully warm and l...

On my innovate mtx-l i display e85 ratios but in nistune still displays gasoline afr's. Any way to change it to display e85 afr's or even lambda?

So my CAS was way off no wonder ran like crap. Got it sorted out for the most part still bit off need to adjust IACV. But here is another short log if someone can tell me if i'm headed in the right direction. This ECU tuning is all new to me i'm trying to get figured out. few revs_2019-08-19_2127_57...

Here is a log at idle not sure if this is how i would post it but looks ok to me. It was at around 14.7ish afr. Timing is all over the place 15* to 30* not sure whats going on there. CAS is maxed out and only able to get 15* on the crank pulley i think it might me off a tooth, would explain very low...

Hey Matt I finally got the car running with the maf and the injectors resized. My issue right now is any throttle I give it i get no response out the engine. I'll open the throttle wide open and nothing rpms go up slightly and very slow. I do have the 10mm bigger throttle body from a s14 sr20de whic...

Yes
Thanks

Awesome that's some good info.
So going to 5ms from 3.5ms I would multiply current values by 1.42?

From what i searched i only saw 1.9ms.

Still no luck starting. I started with stock base map adjusted maf only and car starts, then i did the injectors and now it wont start again. What am i doing wrong. I click the injector size i put in the new injector size 1050 now the tick boxes adjust load scales is unticked, adjust load max limit ...

Not sure if im doing this right but here is what i did i took the 350z dwell 5.0ms/stock sr20 dwell 1.9ms( Can someone verify this is correct)
comes to 2.63 than i multiplied the stock value and came up with this. Is this right?

So i have 350z coils on my s14a sr20det with ignitor deleted. 350z guys run 5.00 to 5.5 ms of dwell. How would i change that on nistune. I see the dwell time/duty table but i dont know what values to enter. Here is what i found guys on PFC using for 5.00001 ms dwell time IGN Dwell vs Time Time = 166...

Ok I'll give that a try. I tought i would have to adjust the crank enrichment but the car is not running right now so I'll try is as soon as it runs. Thanks

Hi everyone im new to all of this so don't have a lot of knowledge but I followed the setup assistance here is what I got. I select my car load base tune, connect to ecu, select maf, resize injectors, and I get no start. I load base map and starts right up. built bottom end s14a sr20det stype 4 boar...