Nistune Forums

Matt, can you please send again the address file to my following address:

dino.rockstroh@gmx.de


Thank you

thanks Matt,

due to problems with our email-server no email from you arrived.

Could you please send it again to my private address: "dino.rockstroh@gmx.de"

Thanks again.

Dino

Hi guys, after a 8 month of break with the whole Z31-mapping stuff i am back again with fresh engine and lots of motivation. I downloaded the latest version of the nistune software (0.90119) and registered with my personal key. Then when i want to open an "adress file" the following messag...

ok, but

do i have to raise the value or decrease with bigger inj. (Benz 420ccm). How is the logic of that value. Higher value = higher latency or the other way round?
I think you use also the Benz injectors. What value would you recommend?

I do not understand that Matt:

I use the stock AFM which reads on Nistune about 0,45 Volts @ idle and ~3,8 Volts@ ~350RWHP.
So i would not make sence to set an offset because 0,45 V @ idle is ok

you know what i mean, bigger injectors need longer to open and close. There is a value in the bins to adjust this latency. According to Jason the adress is HEX:7F88. Where can i change this @Nistune?

Hi Matt, thanks for your detailed reply. Hi Matt, >>1. powering off the ecu, wait 10 seconds, power on the ecu. perform >>an upload to the romulator and see if the ecu works fine I tried this, but nothing changed. At my first shutdown it was not possible any more to connect to nistune for consult mo...

I was doing allot of tuning the last two weeks. Surprisingly sometimes the nistune shuts down completely and sometimes it is just going mad for some seconds. But in both cases there is a great risk of damage to the car. One time the consequence was a damaged AFM (heat wire burnt through). The other ...

>>it appears the vqmap mv table has been screwed up. It should read from 0 to 5120mv? in 80mv increments>> ok, then there is something wrong with the nistune reading this absolutely stock bin i am still using. When i make a datalog maxing out the stock AFM in every rpm range under boost with my big ...

Hi. looking at my first log-files i had problems to interpret some values: TP: my maxvalue was 34816. What unit is that? How many ms is that? AFM: my maxvalue was 3451. What is that unit? How many mv is that? ----- other thing: (see my screenshots attached, second picture): The VQ-Map-chart shows a ...

Hey Matt, the latest bin you patched for me is running well.

Thanky you

just for you to have a look if everything is ok/normal some screenshots:

maptrace works well too!

I will check my fuel-temp-sensor next weekend

Yes i think, so, but the adress file was contained in the latest version of the nistune software, so i did not have to download the adress file extra But i have already fixed that problem, good news, it runs !!!!! I tested some other bins from the patch-folder and when testing the bin ´88SS_nt.binÂ...

Hi Matt,

i tested it with the new patched version but the result was the same: Error message: ´Found invalid Consult RAM adress during USB init´

Dino

Everythink worked well until i tried to start the consult feature. -> Error Message: ´Found invalid Consult RAM adress during USB init. But to start from the beginning: - i installed nistune software (latest version, ..905) - i plugged my ´modded´ ECU to the car - i plugged Romulator and ECU to m...