DLP AD Converter Reading wrong Air/Fuel Ratio on Nistune?
Posted: Mon Oct 06, 2008 7:47 am
The white 0-5v wire from my AEM UEGO was connected to screw terminal #1 on the DLP. The ground on the cars chassis was connected to "GRND" on the DLP. (my wideband is grounded to the chassis as well)
I set the Wideband to configuration > COM4 (com3 didn't connect) (DLP IS selected)
and I set the Lookup table to Program Files > Nistune > Wideband > DLP
AFR and everything is working perfectly, except the AFR's on the wideband are NO WHERE NEARRRR the AFR on the laptop (nistune)
Like the Gauge shows 14.5:1 AFR and Nistune shows 20.0:1 AFR for example.
How can I make it read correctly?
Thanks
I set the Wideband to configuration > COM4 (com3 didn't connect) (DLP IS selected)
and I set the Lookup table to Program Files > Nistune > Wideband > DLP
AFR and everything is working perfectly, except the AFR's on the wideband are NO WHERE NEARRRR the AFR on the laptop (nistune)
Like the Gauge shows 14.5:1 AFR and Nistune shows 20.0:1 AFR for example.
How can I make it read correctly?
Thanks