Nistune Forums

Hey guys, just wondering if you're still working on the launch control update within Nistune, so very keen on this.

Yes. Type 4 OBD-II board issues resolved last week so finishing up hardware changes for this and then working on firmware updates next

Beautiful!

Any update on this for Type 1 boards?

Type 3/4 boards firstly. Lots of work in progress. Having a lot of code to go through

Thanks for the update and all the hard work!

hey matt, just wondering how the coding is going? i know you have been asked a million times but... heres another impatient person haha also once you are done with this and ready to roll out will it just be an update or a mail my ecu to you type thing?

Thanks!

Basically I am updating my disassembler so I can decompile and then recompile the factory code. This part is still in progress and is vehicle dependent. It makes changes easier than patching the code and allows for more change. however it will limit the models I can modify since the process is not automatic. That part is still in progress as well as going through each vehicle code disassembly

sounds like you have your work cut out for you lol good luck and i cant wait to see the final result!

Praying to the Nissan gods this gets done within the next 20 days...

Wont happen before then. Two words... school holidays. Seriously though I work some days between 8-12 hours, and that sometimes doesnt even include time for coding updates due to tech support (forum, email and phone calls) in addition to orders, general enquiries, application debugging and updates

I'm still going through code today for the S14 KA model working through injection routines at the moment

can't wait!!

An update. I've almost finished rewriting my disassembler now for reassembling code. Over 300 instructions so took a bit of time but its back up and working. More progress next week

Any updates on this ?

More school holidays plus other things like the latest software release have delayed things. Working again on it this week