Page 1 of 1
can not find innovate under wide band type
Posted: Fri Sep 02, 2011 2:51 am
by that guy
same as above cannot connect and could'nt find innovate under wide band type look up table configured
Re: can not find innovate under wide band type
Posted: Sat Sep 03, 2011 9:39 am
by bachig24u
Do you remember if you ticked the box for innovate .. during the installation or upgrade questions inthe install wizard?
must have LOGWORKS 3.07 installed before NIStune.
Re: can not find innovate under wide band type
Posted: Thu Feb 16, 2012 1:15 am
by Matt
Next release I've removed the tickbox (always install the LogWorks SDK OCX) however since the DLL needs to be from LogWorks3 to work properly, if it is not detected then you will be notified when selecting 'Innovate MTS' inside File > Configuration
Re: can not find innovate under wide band type
Posted: Thu Feb 16, 2012 1:15 am
by Matt
Next release I've removed the tickbox (always install the LogWorks SDK OCX) however since the DLL needs to be from LogWorks3 to work properly, if it is not detected then you will be notified when selecting 'Innovate MTS' inside File > Configuration and prompted to reinstall LogWorks
Re: can not find innovate under wide band type
Posted: Sun Sep 16, 2012 10:31 pm
by Matt
Note also - Windows Firewall can block 'Innovate MTS' from being available in Nistune. If after reinstalling logworks still not showing then enable Nistune through the firewall (or disable the firewall on private network to see that this is the issue temporarily)