Page 1 of 1
.906a9 Working well so far.
Posted: Fri Jul 14, 2006 1:45 pm
by Stinky
So far things are working well. AFRs are displaying correctly and the bin stayed intact so far. I still need to figure out what the two wideband inputs are doing and do some testing with editing rom locations. Log is attached.
Posted: Mon Jul 17, 2006 11:24 pm
by Matt
the wideband inputs are the likely the third and fourth items configured in your innovate program which are then programmed to the flash device
nistune will always allocate the aux1,aux2,aux3 to the 3 earliest configured values which are not AFR / RPM
so it should look like the following
1. Lambda -> AFR
2. RPM
3. Aux1
4. Aux2
5. Aux3 (to be added to display and logging in NIStune)
6. unused
i will start packaging nistune up soon for a formal release
btw we got our rev3 pcbs today
Posted: Tue Jul 18, 2006 11:23 am
by Stinky
Did some playing around with the aux inputs today. Aux 1 seems to be chts voltage and aux2 seems to be my boost sensor. I'm pretty sure somethings not right between the lm-1 and nistune. After comparing readings from Logworks and from Nistune it seems that Nistune reads as a percentage of 5.00v. In other words if you multiply the nistune value by 5.00v you get the actual voltage value.
Posted: Tue Jul 18, 2006 4:44 pm
by Matt
thats probably right. you need to adjust the aux1.csv and aux2.csv files and adjust the voltage range against an actual range. the values between are interpolated
need to start updating the user manual with all this stuff once concreted
Posted: Wed Jul 19, 2006 1:02 am
by Stinky
ah ok. I'll start playing around with that. Also, could you fix or tell me how to fix having the logs save to c:\.
Posted: Wed Jul 19, 2006 1:50 am
by Matt
new version has the logging going to the proper location