Discussions concerning the M7790 cpu
Moderator: Matt
Fordy
Posts: 153 Joined: Mon Aug 31, 2009 2:20 am
Location: Uk
Post
by Fordy » Mon Sep 28, 2009 1:24 am
on the timing map of a chip i downloaded before fitting the nistune board
i understand in the fuel maps in raw values you may see values higher than 128
but in the timing map i have a low rpm high load section of map where what seems to be is o2 sensor flags active in and values of around 138-150?
i carried out a map trace and the car seems to drive partly through that section and seems to be kinda laggy
Attachments
timing map.jpg
(13.81 KiB) Downloaded 1837 times
Matt
Site Admin
Posts: 8961 Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:
Post
by Matt » Mon Sep 28, 2009 1:48 am
those are knock sensor flags. if it 'thinks' its knocking in that area then it will pull timing / use the knock timing maps
Fordy
Posts: 153 Joined: Mon Aug 31, 2009 2:20 am
Location: Uk
Post
by Fordy » Mon Sep 28, 2009 1:58 am
ok that explains it alot, i thought it was o2 sensing
my timing n knock maps are the same so i'll just get a screen shot of the filtered values and copy them into the raw values to get all the figures the same below 100 so its all uniform
thanks again matt