Hi Matt,
The is one of the board last time I make order,
what I've found on the Nistune software,
the TPS signal & Injector duty did not show,
but these two signal was no problem to show in Nissan Data Scan V1.53,
Could you please check ?
I'm using 0.9.13.10b version
I've also found that, If I uncheck the O2 sensor in feedback switch column, the O2 signal showing 2.48V or something, is that normal ?
If I put a tick on O2 sensor switch, the O2 signal will show 0.32V or 0.33V
(there is no O2 sensor physically connected), If I used wideband analog signal link to ECU, it shows correctly.
Video upload to youtube at
http://www.youtube.com/watch?v=6dZ54AXVasE
Thanks
Louis
TPS signal & Injector duty did not show in Nistune
Moderator: Matt