G'day matt, I have a N14 ECU and a nistune board with N14_SR20DE_68C0F_MT_MT_FP_maps installed on it. Just need to know how do you enable the launch control?
I played around with these settings and nothing happens, also is the launch control partial throttle activated or does it have to be wide open throttle?
Thank you in advance. https://imgur.com/a/R9GzYXy
1. Enable LC + launch flash
2. When CEL flashing, it is enabled
3. Set RPM limit, and speed to disable (eg 20 km/h)
4. LC will disable and CEL stop flashing over 20km/h
Retard limit and timing can be set separately once you have the first bit working
Yes it does stop flashing and nistune is reporting a speed signal. I still can't rev it any higher. I also copied the settings in this video and still got the same result. https://youtu.be/im5to9u0n6Y