Introduction !!!

[korsou]

Hello Guys,

I am just writing to introduce myself. I am from Madrid, Spain and have a built CA18DET with the below list of goodies.

CA18DET with:
knife edged & balanced crankshaft
Pauter Rods
CP, forged pistons with 9,0 : 1 compression ratio
ACL Race bearings
ARP crank, rods & head
Ported and polished head as well as intake manifold to match
topmount exhaust manifold
GT3071 turbo
3" downpipe back exhasut manifold
WALBRO 255LPH pump
custom fuel rail with Bosch 680cc injectors
Front mount intercooler
dual core radiator with 2 electric fans.
Spec 2 stage 3+ clutch
S14a rear diff

I have recently aquired the NISTUNE ECU for my car as this is what I need to get it running properly. Does anyone have any bin files I can use as base file to get mine going? Also any comments will be highly appreciated. My target is to get 375 - 400Hp and have fun driving.

Best regards,

Korsou

[Matt]

Hi Korsou thanks for the introduction. Email me and I can put something to begin with together (info [at]nistune.com)

[korsou]

Hello Matt,

Thanks for the message and the help. I will send you an email as you mentioned.

Thanks again for your help.

Korsou

[ricardomendes]

would like to see how it performs mate, do you have a link of your build?

regards

[korsou]

Hello Ricardo,

No, I regretfully do not have a site with my progress. I have thought about doing it but always put it at the bottom of the list.

When and if I get to it I will certainly do it and inform all.

Thanks and regards,

Korsou