0.10.12 compare dtc filter 2 bug

[bachig24u]

Hi Matt,
I was comparing bins from various extractions when I noticed 'purple' highlighting on dtc filter 2 for no reason.

looking at the comparison value, it appeared the same. The only difference was noticed in dtc filter 1 which also was 'purple' in compare mode.

compare-dtc-bug.jpg

(150.86 KiB) Downloaded 2696 times

not sure if dtc filter tables could be or should be seperated so I though best bring to your attention.

I've attached the bins also.

[Matt]

Yeah shouldnt be highlighted. Added to list

[Matt]

Problem was the address file entry in several address files including CR31

Changing the address file entries from 1,16,1,16 for these to 1,1,1,1 fixes the issue in the interim. I've updated all the address files affected and tested. These will be available in the next release

[bachig24u]

would that have affected the usage of the DTC's..
e.g. not being able to mask them out?

[Matt]

No it doesnt affect those. The ranges in the address files made Nistune comparison think it was a 16x1 table so following bytes after the DTC range were used in comparison

In regards to the actual DTC filter byte changed, only a single value was being altered directly from the flags window