Nistune temp reading on maps

[Preston]

Ok I have recently noticed something (don't know if it's been on-going or not, I just happened to notice it the other day when looking around the maps while bored at work). My consult gauge reading for engine coolant temp is correctly reading (Nistune displays correct temp), but on temp based maps (such as warm enrichment coefficient), it always displays last column (230* +). I have confimed the ECU temp sensor is reading correct temp by thermometer and consult reading, so why are the maps always pegged out? I'm still fairly new to tuning so I don't know if it's affecting anything but it's bothering me that they aren't accessing the right columns. It's an s13 KA type 3 board if it matters.

[Preston]

Nobody else having this problem? Or do you need any more information? I'd like to get this fixed. Thanks.

[Matt]

Should be fixed this in the 0.10.12 version. Had someone email me about this and I fixed before I went overseas

[Preston]

Ok I will install and see...I didn't install .12 yet becuase .11 was still up top I figured maybe it was still being tested or something. Thanks.