Well...I've got another small issue.
*I am able to get the emulator to connect and then USB consult as well, but I noticed something when I attempted to log and make a change to the fuel table:
I was using successfully, a main image I saved back in November 2006, and when I went to change a few fuel table cells up in a high load column....I noticed that when I restarted the engine, I had a bad lean idle and the engine wasn't running at all like it was. I also go an error message when I connected using the emulator button on Nistune.
*It said Error, wrong parameter. I clicked OK and it still connected.
Should I copy all my changes to that Z31_VG30ET_26P00_1988SS_nt main image?
On a side note, when I record a log...I usually pull off the side of the road and stop the log recording. Then I review it, make my changes and re-connect through the steps of clicking the emulator button and then the usb consult. I then start the car and do another log to see the results.
I am not doing anything with any buttons under the operations drop down button or any of the other buttons in the middle of the top of the NisTune screen.
*I mention this just in case there is something that I might be doing wrong with my methods of tuning and making changes.
Dan