I got the new aem inline uego wideband but these don`t work whit the nistune software, some one have any information to make work the new wideband? aem part number 30-2310
Regards.
New inline AEM UEGO
Moderator: Matt
-
- Posts: 21
- Joined: Tue Oct 06, 2009 10:01 am
- Location: Guanajuato México.
Re: New inline AEM UEGO
Not much info on these
Does it work with their software?
Instructions here
http://www.aemelectronics.com/inline-wi ... oller-1159
You need to wire in a RS232 connector to the UEGO (grey to PC RX)
BLACK – Connect to a clean power ground.
GREY – Connect to RS232 serial port on laptop/pc. See section on Serial Data Viewing
If you can get it going with their software, then it should work with Nistune assuming they are still outputting the AFRs in text format, like they did with previous models
Does it work with their software?
Instructions here
http://www.aemelectronics.com/inline-wi ... oller-1159
You need to wire in a RS232 connector to the UEGO (grey to PC RX)
BLACK – Connect to a clean power ground.
GREY – Connect to RS232 serial port on laptop/pc. See section on Serial Data Viewing
If you can get it going with their software, then it should work with Nistune assuming they are still outputting the AFRs in text format, like they did with previous models
-
- Posts: 21
- Joined: Tue Oct 06, 2009 10:01 am
- Location: Guanajuato México.
Re: New inline AEM UEGO
Hi Matt.
I did that, but doesn,t work whit their software, connet but don't have afr still in 18.00.
I did a test using hyper terminal like the olders and don´t work, try whit 19200 bit per sec and work but the text was in volts not in AFR´s
Let me make another test and post the results.
Thanks.
I did that, but doesn,t work whit their software, connet but don't have afr still in 18.00.
I did a test using hyper terminal like the olders and don´t work, try whit 19200 bit per sec and work but the text was in volts not in AFR´s
![Sad :(](./images/smilies/icon_sad.gif)
Let me make another test and post the results.
Thanks.
Re: New inline AEM UEGO
Try and get their software to work first (contact them about getting it working) and then once that goes then might be good
Can you cut/paste sample output of volts? Normally should stream AFRs like
14.7
14.8
14.6
etc
We just read those and pass straight to the display. If its volts then some extra work is required to translate against an AFR look up table, like with some of the other units I support
Can you cut/paste sample output of volts? Normally should stream AFRs like
14.7
14.8
14.6
etc
We just read those and pass straight to the display. If its volts then some extra work is required to translate against an AFR look up table, like with some of the other units I support
-
- Posts: 21
- Joined: Tue Oct 06, 2009 10:01 am
- Location: Guanajuato México.
Re: New inline AEM UEGO
output definitely different than previously
so looks like volt, status, error string
so looks like volt, status, error string