fuel cut - fuel recover type VLT non FP

Nistune topics specific to the 6802 cpu

Moderator: Matt

Post Reply
bachig24u
 

Posts: 677
Joined: Mon Jun 01, 2009 11:46 pm
Location: Campbelltown, NSW
Contact:

fuel cut - fuel recover type VLT non FP

Post by bachig24u »

Hi Matt,
Today I tuned dug out one of our trusty VL circuit cars running on old firmware to convert to E85 but found that the
"fuel cut rpm" "fuel recover rpm" parameter in nistune version 1.2.68 are now missing.
I'm guessing the address file is the issue.

The engine has an issue when the throttle is held at low rpm, around the 1500 mark, it performs a dfco and injection recovery which ias why I need to change the settings.

Can you assist getting them back?
I tried swapping config from Expert to the other modes but still nothing listed.

Kind regards
Simon
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: fuel cut - fuel recover type VLT non FP

Post by Matt »

I'm not sure why I removed these two lines:
#Limit maps
FUEL_RECOVER,&H0000,0,0,0,0
FUEL_CUT,&H0000,0,0,0,0
However if you comment out these lines with # inside VLT_RB30ET_E.adr file then it will show the tables
bachig24u
 

Posts: 677
Joined: Mon Jun 01, 2009 11:46 pm
Location: Campbelltown, NSW
Contact:

Re: fuel cut - fuel recover type VLT non FP

Post by bachig24u »

Thanks for the expedient reply Matt.

Its all sorted.

much appreciated.

KR
Sime
Post Reply