Type 1 z31 fp lc beta test

Nistune topics specific to the 6802 cpu

Moderator: Matt

Post Reply
hausoo
 

Posts: 6
Joined: Thu Jan 16, 2014 3:15 pm

Type 1 z31 fp lc beta test

Post by hausoo »

Hello Matt here's some logs and bin file no flex or clutch switch test. speed trigger working diff mph, launch control working diff rpm's building 5psi manual controller set to 20psi mabey shorter rpm bounce or faster for more boost or is that only possible with negative timing? only issue i see is the maf voltage reading 2-7v instead of 0-5v made a few bin files not sure how to correct it.
couple video's here https://vimeo.com/132486691 showing boost and bounce
Attachments
NIStune_2.csv
(63.65 KiB) Downloaded 162 times
NIStune_1.csv
(77.3 KiB) Downloaded 159 times
L28ET.FORD.MAF.inj437CC.fp43psi.boost20psi.TEST36.fp.bin
(32 KiB) Downloaded 162 times
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Type 1 z31 fp lc beta test

Post by Matt »

MAF voltage is normally 2-7 volts on R31/Z31

When changing to Z32 or other 0-5 volt MAF, once you change the VQ curve, Nistune will remove the MAF 'offset'

You can also disable manually by right click on VQ MAP (MAF translation curve) and disable offset tickbox
URG8RB8
 

Posts: 14
Joined: Tue Mar 06, 2007 6:41 am
Location: Milpitas, CA & Spring Hill, FL

Re: Type 1 z31 fp lc beta test

Post by URG8RB8 »

Not trying to Hi-jack but trying to reach Matt. Please PM if you receive this Matt, Thanks!
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Type 1 z31 fp lc beta test

Post by Matt »

I found it very difficult to track conversations via PM so they are disabled. Please email me instead info[at]nistune.com
Post Reply