Got an old type 1 in here that had no usb, now wont connect

Nistune topics specific to the 6802 cpu

Moderator: Matt

Post Reply
STATUS
 

Posts: 119
Joined: Thu Jun 12, 2008 10:30 pm
Location: Melbourne
Contact:

Got an old type 1 in here that had no usb, now wont connect

Post by STATUS »

Hi have a Type 1 in at the moment that was tuned a few years back in SA it has a 6 pin green connector (x3) on it and the usual x1 and X2 connectors.

It came in with no usb connected to x2 so i fitted one, but nistune wont recognise the ecu.. is there a jumper i need to solder on these older boards to enable USB or is it locked?
Matt
Site Admin
 

Posts: 8961
Joined: Sun Jan 29, 2006 1:45 am
Location: Adelaide, Australia
Contact:

Re: Got an old type 1 in here that had no usb, now wont connect

Post by Matt »

it should work still with the USB connector

Make sure pins are correct way around otherwise we can send you another connector for it
STATUS
 

Posts: 119
Joined: Thu Jun 12, 2008 10:30 pm
Location: Melbourne
Contact:

Re: Got an old type 1 in here that had no usb, now wont connect

Post by STATUS »

Got it sorted i had to back date my drivers to the original setup i had a 2odd years back then it talked fine... odd :P
Post Reply