Hi there,
Can anyone tell me why the status fields in the Consult Display are all ghosted?
I am connected to the ECU, everything works fine but these fields are all grayed out ..
It used to work .. what am I doing wrong?
Many thanks!
Why is this ghosted (Nistune Consult Display)
Moderator: Matt
Why is this ghosted (Nistune Consult Display)
- Attachments
-
- ghosted.jpg
- (62.58 KiB) Downloaded 1894 times
Re: Why is this ghosted (Nistune Consult Display)
Means that likely the consult flags registers are not selected. If we dont see them marked as active I ghost out the display to prevent confusion with thinking that nothing is active (TPS switch, neutral switch etc)
Re: Why is this ghosted (Nistune Consult Display)
That's strange ... I changed nothing ..
I will double check.
Thanks Matt,
Andrew
I will double check.
Thanks Matt,
Andrew
Re: Why is this ghosted (Nistune Consult Display)
Strangely enough it was the consult registers.
So it's all fine now.
Btw.
I found that the display shows VCT as well.
Is that working and could I even log that VCT is on/off?
Thanks ...
So it's all fine now.
Btw.
I found that the display shows VCT as well.
Is that working and could I even log that VCT is on/off?
Thanks ...
Re: Why is this ghosted (Nistune Consult Display)
should display if available in the ECU